Breaking News

Flame Control Coatings Announces Launch of 15-Minute Thermal Barrier for Spray Polyurethane Foam

May 6, 2014

Flame Control Coatings has announced the launch of Flame Control 60-60A Thermal Barrier coating for Spray Polyurethane Foam.  This water-based thin film intumescent coating will provide a 15-minute thermal barrier over Spray Polyurethane Foam insulation.  Flame Control 60-60A is approved for use in occupied spaces where building codes call for the spray foam insulation to be separated from the interior by a 15-minute thermal barrier.
“This innovative coating allows us to meet the ICC requirements while providing an economical and easy-to-use thermal barrier coating to the spray foam industry” said Tim Lockhart, Marketing Manager for Flame Control Coatings.  “The successful performance during the NFPA 286 15-Minute room corner test qualifies 60-60A to be used as an alternative thermal barrier in occupied spaces.  This product is another example of the type of high performance flame retardant and intumescent coatings available from Flame Control.”
Flame Control 60-60A is a water-based latex paint that can be applied by brush, roll or spray. 
For more information on Flame Control 60-60A, please visit
About Flame Control:  Flame Control Coatings is a specialty coatings manufacturers located in Niagara Falls NY.  For over 35 years, Flame Control has been manufacturing flame retardant, heat resistant, and specialty coatings.